100% Free 300-615 Practice Exam Questions and Answers

Stay Ahead with Latest 300-615 CCNP Data Center Practice Test Questions 2026

Page: 1 / 45

Total 221 Questions | Updated On: Sep 22, 2026

Add To Cart

Question 1

Refer to the exhibit. A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit. Which action resolves the issue?

A : Remove the service pack and upgrade through the auto-install procedure

B : Reset the I/O module and install the firmware image from the boot flash

C : Boot the kickstart image from boot flash and load the system image

D : Reload the switch and boot the kickstart image from the TFTP server

Answer: D

Question 2

Refer to the exhibit. During implementation of a Cisco UCS C-Series Server, an engineer receives the status

that is shown in the exhibit. Which action resolves the issue?

A : Insert an SD card into SLOT-2.

B : Reconfigure the Drive Type from “Removable” to “Non-Removable”.

C : Set SLOT-1 Sync Mode to “Auto”.

D : Configure the RAID that is associated with the card.

Answer: C

Question 3

300-615-page127-image8

Refer to the exhibit. A network engineer traces the packet flow from the Veth991 of a blade server toward the

core switch. The switch reports performance issues. What is the role of the interface Eth1/7?

A : IOM network interface

B : fabric interconnect uplink interface

C : IOM host interface

D : server interface

Answer: B

Question 4

300-615-page127-image46

Refer to the exhibit. RBAC is configured on the MDS switch for a new SAN administrator engineer to work on

the FSPF configuration. However, after the configuration is applied the engineer who was assigned the

FSPF_Admin role cannot perform any configuration changes. Which action resolves the issue?

A : Write rule 2 before rule 1

B : Remove rule 1 from the role

C : Configure the switch license for RBAC

D : Reload the switch

Answer: A

Question 5

300-615-page127-image24

Refer to the exhibit. A network engineer configures an EEM script to get a syslog notification after a

configuration change. This message appears when the engineer makes a new configuration to this switch.

Which configuration enables the script to function properly?

A : event cli match ‘configure terminal’

B : event policy-default count 1 time 100

C : event syslog occurs 10

D : action 2.0 event-default

Answer: D

Page: 1 / 45

Total 221 Questions | Updated On: Sep 22, 2026

Add To Cart