Free Practice Cisco 300-620 Exam Questions 2025

Stay ahead with 100% Free Implementing Cisco Application Centric Infrastructure 300-620 Dumps Practice Questions

Page: 1 / 59

Total 294 Questions | Updated On: Mar 02, 2020

Add To Cart

Question 1

An engineer must configure Cisco ACI for VMM integration to VMware vCenter. Which two attributes must be configured on the Cisco APIC to achieve this goal? (Choose two.)

A : cluster name

B : virtual switch name

C : data center name

D : port group

E : logon credentials

Answer: B,E

Question 2

A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

A : Under System -> Faults, right-click on the fault and select Acknowledge Fault so that acknowledged faults will immediately disappear.

B : Create a stats threshold policy with both rising and falling thresholds defined so that the critical severity threshold matches the squelched threshold.

C : Under System -> Faults, right-click on the fault and select Ignore Fault to create a fault severity assignment policy that hides the fault.

D : Create a new global health score policy that ignores specific faults as identified by their unique fault code.

Answer: C

Question 3

An engineer is implementing a connection that represents an external bridged network. Which two configurations are used? (Choose two.)

A : Layer 2 remote fabric

B : Layer 2 outside

C : Layers 2 internal

D : Static path binding

E : VXLAN outside

Answer: B,D

Question 4

An engineer configures an L3Out between BLeaf1 and Core1. A Cisco Nexus 9000 Series Switch runs in NX-OS mode, and the two devices must peer using OSPF. The devices in the network are configured as follows:

• BLeaf1 has been configured with the IP address 10.1.0.2/31 and the router ID 0.0.0.2.

• Core1 has been configured with the IP address 10.1.0.3/31 and the router ID 0.0.0.1.

• On Cisco ACI, the engineer has enabled OSPF using the default OSPF settings.

• The engineer has configured OSPF on the NX-OS switch using the ip router ospf ACI_peering area 1 command.

Which action brings up the OSPF adjacency?

A : Set and Auth Key on Core1.

B : Configure Area 1 on BLeaf1.

C : Disable Hello Timer on BLeaf1.

D : Change the MTU on Core1.

Answer: B

Question 5

A Cisco ACI fabric has 10 standalone leaf switches. The requirement is for the APIC to select the odd switches as a VPC group and select even switches as another VPC group automatically. Which VPC protection type must be configured to accomplish this goal?

A : serial

B : consecutive

C : reciprocal

D : explicit

Answer: D

Page: 1 / 59

Total 294 Questions | Updated On: Mar 02, 2020

Add To Cart