Free Cisco 300-730 Exam Practice Questions 2026

Stay ahead with 100% Free Implementing Secure Solutions with Virtual Private Networks 300-730 Practice Test Questions Dumps

Page: 1 / 38

Total 190 Questions | Updated On: Jul 13, 2026

Add To Cart

Question 1

A network engineer is configuring a server. The router will terminate encrypted VPN connections on g0/0, which is in the VRF "Internet". The cleartext traffic that must be encrypted before being sent out traverses g0/1, which is in the VRF "Internal". Which two VRF-specific configurations allow

VPN traffic to traverse the VRF-aware interfaces? (Choose two.)

A : Under the IKEv2 profile, add the ivrf Internal command.

B : Under the virtual-template interface, add the ip vrf forwarding Internet command.

C : Under the IKEv2 profile, add the match fvrf Internal command.

D : Under the IKEv2 profile, add the match fvrf Internet command

E : Under the virtual-template interface, add the tunnel vrf Internet command.

Answer: B,D

Question 2

Which Cisco AnyConnect component ensures that devices in a specific internal subnet are only accessible

using port 443?

A : routing

B : WebACL

C : split tunnel

D : VPN filter

Answer: D

Question 3

300-730-page53-image32

Refer to the exhibit. Which type of Cisco VPN is shown for group Cisc012345678?

A : Cisco AnyConnect Client VPN

B : DMVPN

C : Clientless SSLVPN

D : GETVPN

Answer: A

Question 4

300-730-page53-image10

Refer to the exhibit. Which value must be configured in the User Group field when the Cisco AnyConnect

Profile is created to connect to an ASA headend with IPsec as the primary protocol?

A : address-pool

B : group-alias

C : group-policy

D : tunnel-group

Answer: D

Question 5

Refer to the exhibit.

An engineer is building an IKEv1 tunnel to a peer Cisco ASA, but the tunnel is failing. Based on the configuration in the exhibit, which action must be taken to allow the VPN tunnel to come up?

A : Add a route for the 10.7.7.0/24 network to egress the outside interface.

B : Enable IKEv1 on the outside interface.

C : Change the IKEv1 policy number to be at least 256.

D : Change the transform set mode to transport.

Answer: B

Page: 1 / 38

Total 190 Questions | Updated On: Jul 13, 2026

Add To Cart