Free Practice API API-936 Exam Questions 2025

Stay ahead with 100% Free Refractory Personnel API-936 Dumps Practice Questions

Page: 1 / 37

Total 185 Questions | Updated On: Jun 05, 2025

Add To Cart

Question 1

For the qualification of the applicator/installer, they shall demonstrate their ability to install the refractory:

A : to meet the specified quality standards utilized for the installation of work.

B : by using the technique prescribed by the manufacturer no matter which material is used.

C : free of visible voids, laminations on the hot face or working surface only for gunned lining.

D : free of visible voids, laminations on the hot face or working surface only of the refractory lining.

Answer: A

Question 2

Which of the following conditions must be met for test results from trial mixes of low cement castables to be accepted for qualification?

A : The water content must not vary more than ±1.0% from that recommended by the manufacturer.

B : Specimens must be fired at 1500°F (815°C) and held for a minimum of 3 hours.

C : Bulk density and CCS must exceed average values published in ASTM C401.

D : The drying process must be conducted at 220°F (104°C) for at least 48 hours before firing.

Answer: A

Question 3

For the qualification of the applicator/installer, they shall demonstrate their ability to install the refractory:

A : to meet the specified quality standards utilized for the installation of work.

B : by using the technique prescribed by the manufacturer no matter which material is used.

C : free of visible voids, laminations on the hot face or working surface only for gunned lining.

D : free of visible voids, laminations on the hot face or working surface only of the refractory lining.

Answer: A

Question 4

For non-erosive service, what is the required number of test specimens per sample for cold crushing strength?

A : 1

B : 2

C : 3

D : 4

Answer: B

Question 5

Which of the following conditions must be met for test results from trial mixes of low cement castables to be accepted for qualification?

A : The water content must not vary more than ±1.0% from that recommended by the manufacturer.

B : Specimens must be fired at 1500°F (815°C) and held for a minimum of 3 hours.

C : Bulk density and CCS must exceed average values published in ASTM C401.

D : The drying process must be conducted at 220°F (104°C) for at least 48 hours before firing.

Answer: A

Page: 1 / 37

Total 185 Questions | Updated On: Jun 05, 2025

Add To Cart