Free Practice Fortinet FCSS_NST_SE-7.4 Exam Questions 2025

Stay ahead with 100% Free FCSS - Network Security 7.4 Support Engineer FCSS_NST_SE-7.4 Dumps Practice Questions

Page: 1 / 14

Total 66 Questions | Updated On: Jun 03, 2025

Add To Cart

Question 1

Exhibit.Refer to the exhibit, which shows the output of diagnose automation test.What can you observe from the output? (Choose two.)

A : The automation stitch test is not being logged.

B : The automation stitch test failed but the HA failover was successful.

C : An HA failover occurred.

D : The test was unsuccessful.

Answer: A,D

Question 2

The local OSPF router is unable to establish adjacency with a peer. Which two things should the administrator do to troubleshoot the issue? (Choose two.)

A : Check whether TCP port 179 is blocked.

B : Check if there is an active static route to the peer.

C : Check whether both peers have an IP address within the same subnet.

D : Check if IP protocol 89 is blocked.

Answer: C,D

Question 3

The local OSPF router is unable to establish adjacency with a peer. Which two things should the administrator do to troubleshoot the issue? (Choose two.)

A : Check whether TCP port 179 is blocked.

B : Check if there is an active static route to the peer.

C : Check whether both peers have an IP address within the same subnet.

D : Check if IP protocol 89 is blocked.

Answer: C,D

Question 4

Refer to the exhibit, which shows the output o! the BGP database.Which two statements are correct? (Choose two.)

A : The advertised prefix of 10.20.30.0'24 was configured using the network command.

B : The first four prefixes are being advertised using a legacy route advertisement.

C : The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.

D : The output shows all prefixes advertised by all neighbors as well as the local router.

Answer: A,D

Question 5

Exhibit.Refer to the exhibit, which shows the output of diagnose automation test.What can you observe from the output? (Choose two.)

A : The automation stitch test is not being logged.

B : The automation stitch test failed but the HA failover was successful.

C : An HA failover occurred.

D : The test was unsuccessful.

Answer: A,D

Page: 1 / 14

Total 66 Questions | Updated On: Jun 03, 2025

Add To Cart