Free Fortinet FCSS_NST_SE-7.6 Exam Practice Questions 2026

Stay ahead with 100% Free Fortinet NSE 6 - Network Security 7.6 Support Engineer FCSS_NST_SE-7.6 Practice Test Questions Dumps

Page: 1 / 27

Total 132 Questions | Updated On: May 23, 2026

Add To Cart

Question 1

Refer to the exhibit.The port1 interface configuration on FortiGate and partial session information for ICMP traffic are shown. Which two things happen to the session information if a routing change occurs that affects this session? (Choose two answers)

A : This session will be unaffected by routing changes. The routing changes will apply only to new sessions.

B : The session will be flagged as dirty but no route lookups will be performed.

C : The session information will not change unless the current route has been removed from the routing table.

D : The session information will not change even when the active route has been removed from the routing table.

Answer: A,C

Question 2

Refer to the exhibit, which shows partial outputs from two routing debug commands.Why is the port2 default route not in the second command output?

A : The port2 interface is disabled in the FortiGate configuration.

B : The port1 default route has a higher priority value than the default route using port2.

C : The port1 default route has a lower priority value than the default route using port2.

D : The port1 default route has a lower distance than the default route using port2.

Answer: D

Question 3

What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow? (Choose two.)

A : Packet was dropped because of policy route misconfiguration.

B : Packet was dropped because of traffic shaping.

C : Trusted host list misconfiguration.

D : VIP or IP pool misconfiguration.

Answer: C,D

Question 4

Refer to the exhibit, which shows the output of a debug command.Which two statements about the output are true? (Choose two.)

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Question 5

Refer to the exhibit. Partial output of a real-time OSPF debug is shown.Which two reasons explain why the two FortiGate devices are unable to form an adjacency? (Choose two.)

A : The remote peer has either OSPF cleartext or MD5 authentication configured.

B : There is an OSPF authentication configuration mismatch.

C : The local FortiGate does not have OSPF authentication configured

D : The local FortiGate has either OSPF cleartext or MD5 authentication configured.

Answer: B,D

Page: 1 / 27

Total 132 Questions | Updated On: May 23, 2026

Add To Cart