Free Practice HP HPE6-A85 Exam Questions 2025

Stay ahead with 100% Free Aruba Certified Campus Access Associate HPE6-A85 Dumps Practice Questions

Page: 1 / 21

Total 105 Questions | Updated On: Jun 03, 2025

Add To Cart

Question 1

When using the network check page in Central, what kind of tests can you run on switches? (Select two.)

A : Speed test (iperf)

B : Ping test

C : A full hardware check, including a heavy memory check

D : LED-check.

E : PoE-check

Answer: B,E

Question 2

What happens when the signal from an AP weakens by being absorbed as it moves through an object?

A : APs will use bonded channels to decrease latency to clients

B : Signal to Noise Ratio (SNR) increases

C : Signal to Noise Ratio (SNR) decreases

D : Aruba Central dynamically moves clients to neighboring APs

Answer: C

Question 3

You are configuring a network with a stacked pair of 6300M switches used for distribution and layer 3 services. You create a new VLAN for users that will be used on multiple access stacks of CX6200 switches connected downstream of the distribution stack You will be creating multiple VLANs/subnets similar to this will be utilized in multiple access stacks What is the correct way to configure the routable interface for the subnet to be associated with this VLAN?

A : Create a physically routed interface in the subnet on the 6300M stack for each downstream switch.

B : Create an SVl in the subnet on each downstream switch

C : Create an SVl in the subnet on the 6300M stack, and assign the management address of each downstream switch stack to a different IP address in the same subnet

D : Create an SVl in the subnet on the 6300M stack.

Answer: D

Question 4

When using the network check page in Central, what kind of tests can you run on switches? (Select two.)

A : Speed test (iperf)

B : Ping test

C : A full hardware check, including a heavy memory check

D : LED-check.

E : PoE-check

Answer: B,E

Question 5

You are working with a pair of 6300M switches in a VSF stack. The switch has 48 SmartRate 5G ports, 2 SFP28 ports, and 2 SFP56 ports. Both SFP56 ports are used for stacking. You need to provide an LACP connection to another identical stack with the maximum available bandwidth possible. What should you configure?

A : a 16-member LAG using 2 SFP28 ports and 6 SR5 ports on each switch

B : an eight-member LAG using 4 SR5 ports on each switch

C : an eight-member LAG using 2 SFP28 ports and 2 SR5 ports on each switch

D : a four-member LAG using 2 SFP28 ports on each switch

Answer: A

Page: 1 / 21

Total 105 Questions | Updated On: Jun 03, 2025

Add To Cart