100% Free Juniper JN0-232 Practice Test Questions

Question 1

You want to confirm that your SRX Series Firewall is connected to the SBL server. Which operational mode command would you use in this scenario?

A : show security utm anti-virus status

B : show security web filtering status

C : show security utm content-filtering statistics

D : show security utm anti-spam status

Answer: B

Question 2

Which type of NAT performs port address translation?

A : interface-based source NAT

B : static NAT

C : source NAT with address shifting

D : destination NAT without port forwarding

Answer: A

Question 3

You have a situation where legitimate traffic is incorrectly identified as malicious by your screen options. In this scenario, what should you do?

A : Enable all screen options.

B : Discard the traffic immediately.

C : Increase the sensitivity of the screen options.

D : Use the alarm-without-drop configuration parameter.

Answer: D

Question 4

You are asked to reduce security configuration complexity on your external facing firewalls. You notice that a previous administrator included hundreds of private subnet NAT rules covering various RFC1918 addresses. You want to replace all these rules with a single rule covering all RFC1918 addresses. Which rule would you use in this scenario?

A : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 192.168.0.0/16 172.16.0.0/12]

B : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 192.16.0.0/12 172.168.0.0/16]

C : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 172.168.0.0/16 192.0.2.0/24 203.1.113.0/24]

D : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 192.168.0.0/16 172.16.0.0/12 192.0.2.0/24]

Answer: A

Question 5

You are asked to reduce security configuration complexity on your external facing firewalls. You notice that a previous administrator included hundreds of private subnet NAT rules covering various RFC1918 addresses. You want to replace all these rules with a single rule covering all RFC1918 addresses. Which rule would you use in this scenario?

A : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 192.168.0.0/16 172.16.0.0/12]

B : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 192.16.0.0/12 172.168.0.0/16]

C : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 172.168.0.0/16 192.0.2.0/24 203.1.113.0/24]

D : set security nat source rule-set private-to-pub rule RFC1918 match source-address [10.0.0.0/8 192.168.0.0/16 172.16.0.0/12 192.0.2.0/24]

Answer: A

100% Free JN0-232 Practice Exam Questions (2026)