Free Practice Juniper JN0-637 Exam Questions 2025

Stay ahead with 100% Free Security - Professional (JNCIP-SEC) JN0-637 Dumps Practice Questions

Page: 1 / 22

Total 107 Questions | Updated On: Oct 20, 2024

Add To Cart

Question 1

What are three requirements to run OSPF over GRE over IPsec? (Choose Three)

A : The GRE interface must be configured in OSPF Area 0.

B : The OSPF interface must be placed in a zone and must have GRE configured

C : Overlapping addresses should exist between remote networks.

D : The GRE interface must be placed in a zone and must have OSPF configured in is host

E : Overlapping addresses should not exist between remote networks.

Answer: B,D,E

Question 2

Which two statements about transparent mode and Ethernet switching mode on an SRX series device are correct.

A : In Ethernet switching mode, Layer 2 interfaces must be placed in a security zone.

B : In Ethernet switching mode, IRB interfaces must be placed in a security zone.

C : In transparent mode, Layer 2 interfaces must be placed in a security zone.

D : In transparent mode, IRB interfaces must be placed in a security zone.

Answer: B,C

Question 3

What are three requirements to run OSPF over GRE over IPsec? (Choose Three)

A : The GRE interface must be configured in OSPF Area 0.

B : The OSPF interface must be placed in a zone and must have GRE configured

C : Overlapping addresses should exist between remote networks.

D : The GRE interface must be placed in a zone and must have OSPF configured in is host

E : Overlapping addresses should not exist between remote networks.

Answer: B,D,E

Question 4

You want to create a connection for communication between tenant systems without using physical revenueports on the SRX Series device.What are two ways to accomplish this task? (Choose two.)

A : Use an external router.

B : Use an interconnect VPLS switch.

C : Use a secure wire.

D : Use a point-to-point logical tunnel

Answer: C,D

Question 5

Exhibit:You are configuring NAT64 on your SRX Series device. You have committed the configuration shown in theexhibit. Unfortunately, the communication with the 10.10.201.10 server is not working. You have verifiedthat the interfaces, security zones, and security policies are all correctly configured.In this scenario, which action will solve this issue?

A : Configure source NAT to translate return traffic from IPv4 address to the IPv6 address of your source device.

B : Configure proxy-ARP on the external IPv4 interface for the 10.10.201.10/32 address.

C : Configure proxy-NDP on the IPv6 interface for the 2001:db8::1/128 address.

D : Configure destination NAT to translate return traffic from the IPv4 address to the IPv6 address of your source device.

Answer: A

Page: 1 / 22

Total 107 Questions | Updated On: Oct 20, 2024

Add To Cart