Free Practice Nutanix NCS-Core Exam Questions 2025

Stay ahead with 100% Free Nutanix Certified Services Core Infrastructure Professional NCS-Core Dumps Practice Questions

Page: 1 / 61

Total 305 Questions | Updated On: Apr 21, 2025

Add To Cart

Question 1

An administrator responsible for a VDI environment needs to investigate reports of slow logins. Theadministrator finds that increasing the number of vCPUs from 2 to 4 will reduce the login times. Production workloads are consuming 75% of the host CPU on the cluster. The administrator increases the vCPU count on all of the VDI VMs. What are two impacts on the cluster? (Choose two.)

A : Increase CPU utilization%

B : Increase CPU ready%

C : Increase memory utilization%

D : Increasing CPU counts will decrease memory utilization

Answer: A,B

Question 2

Refer to the exhibits.

An administrator has reported that a new VM is not performing well.

After analyzing the information presented in the exhibits, which option shows the best conclusion regarding this workload?

A : VM is CPU constrained since the hypervisor cannot provide the required resources.

B : VM is CPU constrained because more CPU needs to be added to the VM.

C : VM is Storage constrained, because the workload is waiting for storage access.

D : VM is not CPU constrained, because the VM is not running, a multithreaded application.

Answer: C

Question 3

A consultant is preparing for a cluster deployment and evaluates portable Foundation. Laptop configuration is as follows: •CPU: 2.8 GHz Quad-Core Intel Core i7 •Memory: 4GB RAM During the installation, the consultant encounters some errors and tries to troubleshoot. What could prevent successful installation and Foundation usage?

A : Gatekeeper must be enabled

B : Oracle VirtualBox is installed on the laptop

C : Laptop configuration does not meet installation requirements

D : Firewall Stealth Mode is disabled

Answer: C

Question 4

An alert about RX errors on eth2 on a node is reported in the cluster. The administrator logs in to theCVM in

question, checks the ping_* files in the data/logs/syststats folder, and notices intermittent ping loss.

The node in question has the following network configuration:

Which action should be used to troubleshoot without disrupting the VMs running on this node?

A : Replace the cable from eth2 to the switch

B : Remove eth3 from br0-up and monitor for new alerts

C : Check the port on the switch side for any errors

D : Enable balance-s1b on br0-up and monitor if a problem persists

Answer: C

Question 5

An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own

block, theother 2 nodes where added to an existing share. After adding the nodes, the administrator sees that

the hardware tab displays the correct number of nodes, but incorrect position in the diagram tab.

What should the administrator do to resolve the issue?

A : Check the factory_config.json for all 3 nodes

B : SSH into CVM and perform genesis restart on each CVM

C : SSH into the CVMs and run genesis acropolis stop; cluster start

D : Check the factory_config. json for the two single nodes.

Answer: D

Page: 1 / 61

Total 305 Questions | Updated On: Apr 21, 2025

Add To Cart