Free Practice NetApp NS0-093 Exam Questions 2025

Stay ahead with 100% Free NetApp Accredited Hardware Support Engineer NS0-093 Dumps Practice Questions

Page: 1 / 13

Total 61 Questions | Updated On: Jun 03, 2025

Add To Cart

Question 1

A SAS connection is reporting a single PHY down. What are the two most likely causes? (Choose two.)

A : improperly seated cable

B : outdated I/O module (IOM1 firmware

C : defective cable

D : an offline shelf in the stack

Answer: A,C

Question 2

Which command can you use to confirm successful completion of an ONTAP upgrade?

A : system controller sp upgrade show

B : cluster image show-update-progress

C : job show “jobtype upgrade

D : system node upgrade-revert upgrade-task “node “version

Answer: B

Question 3

You have replaced a failed boot device. You perform boot_recovery and receive no errors. However, when the node reboots, it reports that it has no disks. What are two possible causes? (Choose two.)

A : The SAS cables were incorrectly reconnected after reinstalling the motherboard.

B : The disks that are owned by this node have been marked as failed.

C : The node is booting a lower version of ONTAP software than was last used.

D : The interconnect is down.

Answer: A

Question 4

When you add a new disk to an ONTAP 9.1 system, you see an error that the disk œhas raid label with version (16), which is not within the currently supported range (14-15). What is one possible cause of this error?

A : The disk is a non-zeroed spare.

B : The disk firmware is too new for ONTAP software.

C : The disk needs to be assigned to the new system.

D : The disk was in a system with a newer version of ONTAP software

Answer: D

Question 5